Form labs logo Tie Clip

I actually lied in my first post because this is the very first print I made with my Form 2 3D printer  a couple of weeks ago. I think it comes preloaded with the printer and I printed it to see if I installed everything correctly and if the printer was working properly. I’m not so much of a tie guy myself and I would certainly not wear a tacky self printed tie clip, but the print came out looking quite good.

IMG 5555

 

 

 

 

 

 

 

 

 

The edges look rough due to the supports that I printed and didn’t sand or polish afterwards. All in all I am happy with the results and I need to gain some experience in post processing to get a smooth finish and the best results.

IMG 5554

Leave a Reply

Your email address will not be published. Required fields are marked *